Progressive-industries Remote Bypass Manuale Utente Scaricare il pdf

REMOTE BYPASS SWITCH INSTRUCTIONS

1. Determine where the switch box is to be located

(maximum of 4 ft from EMS).

2. Strip back switch end one inch and conductors 3/8”.

3. Crimp on smaller of two female terminals.

4. Attach black conductor to center tab on switch.

5. Attach red conductor to either free tab on switch.

6. Place switch in box and mount box. Cable needs to

come out U-shaped hole on side, so box mounts flush to

surface without crimping cable.

7. Strip EMS end to 3 inches and conductors 3/8”.

8. Crimp remaining female terminals onto cable.

9. Feed cable into input end of EMS.

10. Attach black conductor to blank male terminal located

on input side under the white power cord neutral.

11. Remove blue jumper wire that is attached to relay on

one end and the other is not connected to anything.

Replace blue jumper with red switch wire.

12. Replace EMS cover, and apply power to EMS.

13. Next, be sure switch is mounted properly according to

printing on box, if not, remove switch, NOT box and

orientate so that switch is matched up to box printing.

(If there is no delay when power is

applied, the EMS is in bypass)

14. Installation is complete. If you have any questions,

please call:

Progressive Industries, Inc.

Monday – Friday, 9 a.m. to 5 p.m.

(919) 462-8280

Pagina 1

REMOTE BYPASS SWITCH INSTRUCTIONS 1. Determine where the switch box is to be located (maximum of 4 ft from EMS). 2. Strip back switch end one inch

Nessun commento

Progressive-industries Remote Bypass Manuale Utente